Blog

The role of the fog system is to use tap water or water in the pool, through the transmission of high-pressure equipment in the air to form flying water mist, which can make the use of the site uninterrupted underground “drizzle”, adsorbing dust particles and impurities in the air, and play a dust suppression role. After a period of air spraying, it can moisten the ground, and stop the dust from being raised again. In the hot season, it can also reduce the indoor and outdoor temperature and play a cooling role. So the equipment is also very suitable for use in farms.

Cooling and fogger system on farm

The high temperature in summer is a very big problem for farmers, because when the temperature of the farm reaches more than 30 ° C, livestock is easy to get heat stroke, especially pregnant female livestock and small livestock, so we must do a good job of heat prevention and cooling. Of course, there are many ways to prevent summer heat cooling, but now everyone is basically the choice of spray cooling, because it will be better than the traditional cooling effect, and the spray device can also be used as disinfection. The following spray cooling equipment Xiaobian for everyone to share the farm installation of spray cooling equipment precautions:
The spray cooling equipment used in the farm uses pressurized water to form small droplets after the nozzle, which float in the air in the greenhouse and exchange heat and humidity with the air to achieve the effect of evaporation and cooling. However, the spray will hit the wetland surface, cause water on the ground, and make the livestock in a high humidity environment for a long time, which causes harm to the environmental health of the farm, so pay special attention to the use of the spray device when cooling, mainly in the selection of the nozzle, the height of the nozzle installation and the spray time of these three aspects.

misting cooling system

First, the choice of misting cooling system nozzle
The key is to atomize the nozzle well. The performance of the nozzle directly affects the quality of atomization, and the quality of atomization directly affects the cooling effect. A good performance nozzle, not only can provide good atomization effect, but also should consume less energy. Such as fine mist, even the humidity of the fermentation bed is not harmful, because the water generally rarely falls into the bedding, but is atomized in the air, and absorbs the heat in the air and evaporates, and will not fall on the bed.
Second, the height of the spray cooling device nozzle installation
The droplets run in the farm, and due to the initial velocity of the droplets and the action of gravity, the droplets will move downward. If a large number of small droplets are inhaled by livestock, it is easy to cause respiratory diseases. From this point of view, there is a certain limit to the space for the droplets to run in the farm, that is, the droplets should completely evaporate above the livestock, that is, the height above the livestock stall. The specific height is determined by the selected nozzle pressure and the nozzle device Angle.
Three, spray cooling spray time
Taking intermittent operation mode, spray cooling, as the temperature drops, the moisture content of the air increases. After a certain time (about 1-2 minutes according to the test), the moisture and heat balance is reached, and the water vapor content of the air in the house is close to saturation. Therefore, the nozzle must periodically work intermittently, depending on the temperature, humidity, ventilation and other conditions.